![]() That is the biggest problem with the factory adapter. A properly designed SDS100 BNC adapter uses the collar for support, transferring much of the impact stress if you drop the radio to the case instead of the SMA connector.That decreases wear on the SMA connector by a factor of 1000 or more. If the adapter wears out, changing it is equivalent to one SMA antenna swap. ![]() Using an adapter shifts the wear of changing antennas to the adapter.BNC connectors are stronger than SMA connectors, and less likely to break if you drop the radio.BNC connectors are designed to handle more connect/disconnect cycles before wearing out than SMA connectors.Figure 1: 7078-TRX-BNC 3-Slot Triaxial to BNC adapter To maintain maximum insulation resistance, keep the connectors free of contaminants (such as dirt or oil). It can be used to connect BNC cables to equipment having female, three-lug triaxial connectors. BNC is standardized in that regard, so any correctly manufactured BNC antenna will fit on a BNC connector. Description The Model 7078-TRX-BNC is a male, three-slot triaxial to female BNC adapter.Some will expect the connector to protrude more, and some less. ![]() Reactions: trido, rgchristy, garys and 5 others. ![]() So no matter how much of the collar you shave off, you're going to have fitment issues with some SMA antennas. A properly designed SDS100 BNC adapter uses the collar for support, transferring much of the impact stress if you drop the radio to the case instead of the SMA connector.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |